LumitexT – Endurance test 4x strip LumiBOX-XT(NV) 350mm 3-LED

Posted by Marcel van der Steen in Endurance Test No Comments»

LumitexT has put 4 LED-strips in endurance test.

This article presents the endurance test results. The test has run more than 6,000 hours. Then the test went on until 8,400 hours. The graphs have been updated.

See also the results of the 0-hours test.

Summary Measurement Data

parameter initially after 6,200 hrs endurance
Color Temperature 6309 K 6284 K
Luminous Intensity Iv 7548 Cd 7184 Cd
Beam Angle 15, 42 deg 16, 41 deg
Power P 37.6 W 37.7 W
Power Factor 0.43 0.44
Luminous Flux 1930 lm 1881 lm
Luminous Efficacy 51 lm/W 50 lm/W
CRI_Ra 71 71
Coordinates Chromaticity Diagram x=0.3184 and y=0.3123 x=0.3186 and y=0.3127

Test duration and test environment

The lamp went into endurance test on 28 Jan 2014 and this reporting covers until 14 Oct 2014. The the test went on until mid Jan 2015.

During this period of time the lamp has seen the following variation in enviromental temperatures and humidity: the temperature close to the lamp varied between 8 – 30 deg C and the humidity betwen 25 – 80 %. The tube has been in a garage.

Variation of lamp parameters

 

Lumitext_Pars_8400hrs

The variation of the lamp parameters during the endurance test.

See the explanation on the OliNo site for more on the test method.

The extrapolation to the 70 % level of the luminous flux is possible when using the illuminance as a measure for the luminous flux (the level is basically constant).

 

Lumitext_Ev_8400hrs

Extrapolation of the illuminance.

See the explanation on the OliNo site for more explanation and the link to the ASSIST document for the method of extrapolation.

The extrapolation of this data until 70 % of illuminance is reached goes beyond the 5 – 6 x the tested time, so the 70 % luminous flux quantity is expected to happen after 50,000 hours.

Color change

The color change (change in color coordinates) is measured during the first 8,400 hours.

1stepMacAdams_8400hrs

 

Change in color coordinates during the endurance test.

The color coordinates indicated with the red cross-hairs are the coordinates after 1000 burn hours. These are taken as reference. After 8,400 hours the color point remains well inside an 1-step McAdams ellipse. This is a very good result for constancy of color.

Leave a Reply

Your email address will not be published. Required fields are marked *